Bultaco Brinco Parts

brecs

Bultaco Brinco Manual – English Language – click here for the PDF format
Bultaco Brinco Manual – Spanish Language – click here for the PDF format

1 chassis with seat2 fork3 swingarm and shock4 steering and handlebar5 front wheel6 rear wheel7 front brake8 rear brake9 installation 12v10 Transmission11 Power Battery12 Plastics13 Bottom Bracket14 Decals

Battery advice from the UserManualBrinco:
FULLY CHARGE THE BATTERY BEFORE FIRST USE. TO REACH MAXIMUM BATTERY PERFORMANCE AT LEAST 5 CYCLES OF DISCHARGE AND CHARGE ARE REQUIRED. TO GET THE MOST OUT OF THE BATTERY, RECHARGE IT IMMEDIATELY AFTER EACH RIDE! DO NOT INTERRUPT THE CHARGING PROCESS UNTIL THE BATTERY IS FULLY CHARGED. BATTERY CHARGE INTERRUPTION COULD CAUSE LOSS OF CAPACITY OR PREMATURE BATTERY FAILURE. THE BATTERY MAY BE DAMAGED IF IT IS FULLY DISCHARGED.
ECO MODE IS THE MOST RECOMMENDED ONE FOR USE IN AREAS WITH STRONG
AND LONG HIKES. IF THE PERFORMANCE DEMAND EXCEEDS THE PHYSICAL LIMITS OF THE BRINCO, THE POWER WILL BE TEMPORARILY DISCONNECTED UNTIL THE SYSTEM TEMPERATURE DROPS SUFFICIENTLY TO RESTART THE VEHICLE. If the warning light flashes, remember to reduce the level of performance demand that you are applying to your Brinco and help by pedaling before the light becomes steady since then, the protection system disconnects power.
IN WINTER, IF YOU’RE NOT USING YOUR BRINCO, WE RECOMMEND TO LEAVE IT CONNECTED TO THE CHARGER CONTINUOUSLY. IN SUMMER, REMEMBER THAT THE TEMPERATURE RANGE FOR CHARGING IS 0 TO 40 ºC. TEMPERATURE RANGE FOR OPERATING YOUR BRINCO IS BETWEEN -20 °C / -4 °F AND 55 °C / 131 °F. If the batteries are exposed to too low temperatures when the Brinco is parked outside, the rider may see a temporary reduction in range or maximum power delivery when riding. Avoid parking the vehicle in places where ambient temperature is below -20 °C/-4 °F. Heat is also important. Charging your battery at a temperature above 40 °C/104 °F can damage the battery and shorten its lifespan. After the battery is fully charged, as long as the charger is plugged, the charger will check the state of charge periodically to ensure that the charge is complete. If the charger does not indicate that the battery is fully charged, it will still try to charge fully.
If you will not use the vehicle for long periods of time you must disconnect the battery from the moto-bike, but we recommend to keep the Brinco battery connected to the charger if it is not going to be used for more than 30 days. In case you decide not to keep the battery connected to the charger, make sure you remember to perform a charge of at least two hours every 30 days. If during a long trip the level of the battery charge achieved 25% (2 bars on the dashboard) of total capacity, the battery management system would switch to ECO mode automatically. The system would be deactivated before total battery discharge occurred.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s