happy ebiking in 2017

Cube say that one in four of the bikes that they sell are e-bikes. cube-elly-1024x679
cubektmscottsdurorotwildDUAL battery by Bosch – Y-cable connector & Intuvia or Nyon displays. 2x500w=200km on flat, or 100km in off-road. The controller intelligently manages the two batteries, switching between them when charging and discharging.reissemullerfluxbullscannondalegiantstrommerSram EX1  the world’s first drivetrain system specifically developed for E-MTBs.sram-ex1-schaltung-drivetrain-8-gaenge-e-mountainbike-ebike-mtb-com-6-von-2480-100km/h – with high power hub motors & big 72v  batteries.enduro-frameRC engines + recent developments in controller technology: up to 6Nm/kg, a 2.5kg can give as much power as a 1500cc / 30HP gas engine. (top power9800W – 51.8V190A)
150ccoutrider56hp22HP continuous power, 10.5kg, Triple AstroFlight 3220 Motor System:
• Motors: 3x air cooled AstroFlight 3220, custom machined cans and billet cooling fans, 3 turn Wye, sensorless with custom 1/2” heavy duty shaft.
• Reduction unit: This is a drive unit with a custom motor plate, extra wide belt, custom motor pulleys, heavy duty idlers, extra large output shaft with keyway and extremely high output freewheel. Use a heavy duty trials bicycle chain.
• Controllers: Castle Creations Edge 160HV programmed for EV use and high amp running 280A each x3 = 840A total
• Throttle: few tricks to connect a 5v Magura throttle to a radio controlled (wireless) motor controller. It also has a “throttle end point”, a potentiometer that you can limit the maximum power output by limiting the throttle maximum voltage.
• Shunt, 2x bus bars and 3x 300A DC circuit breakers
• Continuous / Peak Amperage (all 3 motors together) = Peak amperage is 280 per motor (so 840 amps total) for 2 seconds, 690 amps for 15 seconds, and 400 amps continuous.
• System Peak Power (watts / HP) = Peak wattage is 14,000 per motor (42,000 for all three). Divide that by 746 for HP, basically 56hp
• Torque = Peak torque at each motor shaft is 15 ft pounds. That is each of the three motors. Continuous torque is 5ft pounds per motor. So, you are looking at 235ft pounds at the freewheel. Therefore, if the radio is 3 to 1 from freewheel to the wheel, you are looking at 800 ft pounds of torque at the rear wheel (peak).
• System Continuous Power (watts / HP) = 22hp continuous for the three motor system.
• Motor maximum RPM = 11,300
• Weight of the drive including controllers = around 10.5kg (23 pounds)
2017

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s